Posted by : Abdul Munaf Tuesday, October 2, 2012

Requirements:

*USB Flash Drive (Minimum 4GB)

*Windows 7 or Windows 8 installation files.

Follow the below steps to create bootable Windows 7/Windows 8 USB drive using which you can install Windows 7 or Windows 8 easily.

Procedure:

1. Plug-in your USB flash drive to USB port and move all the contents from USB drive to a safe location on your system.

2. Open Command Prompt with admin rights. Use any of the below methods to open Command Prompt with admin rights.

*Type cmd in Start menu search box and hit CtrlShiftEnter.

Or

*Go to Start menu > All programs > Accessories, right click on Command Prompt and select Run as administrator.

3. You need to know about the USB drive a little bit. Type in the following commands in the command prompt:

First type DISKPART and hit enter.
Next type LIST DISK command and note down the Disk number (ex: Disk 1) of your USB flash drive. In the below screenshot my Flash Drive Disk no is Disk 1.

4. Next type all the below commands one by one. Here I assume that your disk drive no is “Disk 1”.If you have Disk 2 as your USB flash drive then use Disk 2.Refer the above step to confirm it.

So below are the commands you need to type and execute one by one:

SELECT DISK 1

CLEAN

CREATE PARTITION PRIMARY

SELECT PARTITION 1

ACTIVE

FORMAT FS=NTFS

(Format process may take few seconds)

ASSIGN

EXIT

Don’t close the command prompt as we need to execute one more command at the next step. Just minimize it.

5. Next insert your Windows7/Windows 8 DVD into the optical drive and check the drive letter of the DVD drive. In this guide I will assume that your DVD drive letter is “D” and USB drive letter is “H” (open my computer to know about it).

6. Maximize the minimized Command Prompt in the 4th step.Type  the following command now:

D: CD BOOT and hit enter.Where “D” is your DVD drive letter.

CD BOOT and hit enter to see the below message.

7. Type another command given below to update the USB drive with BOOTMGR compatible code.

BOOTSECT.EXE /NT60 H:

Where “H” is your USB drive letter. Once you enter the above command you will see the below message.

8. Copy your Windows 7 or Windows 8 DVD contents to the USB flash drive.

9. Your USB drive is ready to boot and install Windows 7 or Windows 8.

Picture

Tags: , , , , , ,

Leave a Reply

Like us on FB

Popular Post

Contact Form

Name

Email *

Message *

Advertisement

Rs. 150 .Com at GoDaddy.com! Rs. 109 .Com at GoDaddy.com!

Advertisement

Powered by Blogger.

Administrator

Visitors

Copyright © TechBuzz18. All Rights Reserved, The content, posted after January 1st 2014 is copyrighted to TechBuzz18 and may not reproduced on other websites. | Powered by TechBuzz18